You should be ready to install a package very shortly after it arrives,i.e., you have a bee hive all set up and ready for the bees. It is not in the best interests of the bees to keep them in the package box any longer then necessary. Before you prepare everything to get ready for the installation spray a sugar syrup mixture ( 1 : 1 mixture of water and sugar ) on the package screening. This will help to keep them occupied and remain calm.

This is a Queen Cage with a Queen and a couple of attendants inside with her. One end of the the cage has been drilled out and filled with a bee candy so that she cannot escape.

This Queen Bee has not been raised with this collection of worker bees. If she were thrown in with these workers unprotected when the package was being put together, they would immediately kill her because she is not 'one of them'. While she is in this cage during shipment they get used to the pheromones she is constantly giving off and she and the workers become family so to speak. So when she is finally released from her cage she is 'one of them'.

So, now you have the package of bees next to the open bee hive in which they are going to be installed. Be sure you have placed an entrance reducer in the hive opening on the bottom board. This is for the purpose of making it easier for them to defend the smaller entrance to the hive should a horde of robber bees descend upon the bee.

Pry off the wood cover of the package box. Gently slide out the large can of sugar syrup and place it to the side. Pull out the small wooden cage with the Queen and slip it in to your pocket to keep her out of harm's way and warm.

When you are ready to shake the bees out of the box into their new home take the Queen Cage out of your pocket and using a small nail insert it into the bee candy and make a narrow hole. This is to help the worker bees now in the hive eat their way thru to enable the Queen to enter her new home. At this point you don't want her coming out thru the tunnel and perhaps falling to the ground and getting injured or possibly stepped on or disappear from our sight.

Suspend the Queen Cage by gently putting it between the two frames about four frames in from the side of the hive box. Position the cage with the bee candy plugged hole facing down towards the bottom board and make sure the frames on each side of the cage are pushed together securely.. The bees will chew through the bee candy plug and release the queen within a few hours. Do not put the queen cage under the opening in the inner cover with the sugar syrup feeder sitting above it.

Bang the package box on the ground a couple of times to get most of the bees to fall towards the bottom of the box. Pick up the box and invert it over the center of the hive box and give it a few healthy shakes so that the majority of the bees will fall down between the frames. It's okay to bang the edge of the box to shake some of the remaining bees loose. Some bees will fly around but don't worry about them as they will not fly away. There will still be some bees stubbornly staying inside the package box.

Place the box on the ground in front of the hive with the opened area facing towards the bottom board. The bees remaining inside will eventually all crawl out on their own and march inside the entrance to the hive.

Close your hive up leaving the package bee box where it is on the ground.

Come back in a couple of days to check if the queen has been released from her cage. If she has not then gently lift the cage out and widen the bee candy tunnel making sure once again that she does not fall out. Replace the cage and check it the following day.

Make sure that you keep them supplied with sugar syrup until they start building up their own supplies.

Check Out Our Video On How Install Package Bees